Flow Meter CMM 500 for Accurate Measurement of Compressor Performance

The company «Izmerkon» is pleased to present the new flow meter CMM 500, specially designed for accurate measurement of compressor equipment performance and accounting for compressed air consumption. This modern solution allows effective control of compressed air and other gas flow, ensuring reliability and cost-efficiency in industrial processes.

The device is universal – suitable for working with wet air immediately after the compressor, as well as for monitoring dry compressed air in monitoring and accounting systems.

Key advantages of CMM 500

• Measurement range – ratio 1:130 covers a wide range of operating modes.
• High accuracy – error does not exceed 0.5% of the measured value (in the range from 0.2 Qmax to Qmax).
• Fast response time, peak detection, no time required for adaptation.
• Very low pressure loss - less than 70 mbar at maximum flow.
• Operating pressure up to 10 bar, 30 bar, or 100 bar.
• Digital interfaces Modbus-RTU, Modbus TCP, POE, MBus, HART and analog output 4...20 mA.
• Explosion-proof version of the flow meter for combustible gases.

Ease of maintenance without stopping operation

The device is designed with the needs of industrial operation in mind:

Maintenance access under pressure – thanks to a special mounting plate, it is possible to perform:

• zero point adjustment,

• removal of accumulated condensate,

• sensor replacement for calibration.

Minimal downtime – all operations are carried out without stopping the system, which is especially important for continuous production processes.

CMM 500 combines reference accuracy, reliability, and ease of use, making it the optimal solution for controlling compressors and compressed air systems.

For consultation and more detailed information, contact our specialists by phone +7 (812) 309 56 05 or via the feedback form.